CWDM-10G-SFP-100

    10G CWDM SFP+ transceiver 100km is a Multi-Vendor MSA Compliant SFP+ (Small Form Factor Pluggable) Transceiver that operates over a Double Fiber CWDM Single-Mode Fiber (SMF) optical cable. It has a minimum guaranteed optical budget of 26 dB, which is typically enough to reach a distance of about 100 km. However, distance is only an indicative parameter calculated for identification comfort. Finally, we calculate distance while keeping in mind the minimum optical budget and the average attenuation of optical cabling in industry. 10G CWDM SFP+ uses a high-quality EML transmitter with a nominal wavelength ranging from 1470nm to 1550nm and a 1270-1610nm APD Photodiode receiver. 10G CWDM SFP+ transceiver 100km have a dispersion tolerance of 2000 ps/nm. Higher CWDM wavelengths (1570, 1590, 1610nm) for 100 km product in the selection bar are not available, as these wavelengths are impacted by high dispersion and can’t fulfill 100km requirements.

   DDM/DOM optical diagnostics are supported by this 10G SFP+ CWDM 100km, which provides diagnostic information about the current operating conditions. The CWDM-10G-SFP-100 has a Double LC interface and operates in the standard 0°-70°C temperature range. SFP+ supports data rates ranging from 9.95 to 11.32Gbps and applications such as 10G Ethernet (10.31Gbps), STM-64 (9.95Gbps), ODU2 (10.037Gbps), ODU2e (10.399Gbps), OTU2 (10.70Gbps), OTU1f (11.27Gbps), OTU2f (11.32Gbps), OTU1e (11.049Gbps), OTU2e (11.095Gps). SFP+ Double Fiber CWDM-10G-SFP-100 CWDM optical transceiver is a multi-purpose module that is used in a variety of networking applications today. As a result, Internet Service Provider (ISP) Fiber To The Home aggregation and backbone, Mobile operator core and backhaul SDH/SONET applications, Data Center networking site interconnections, and other optical links are the most popular applications.

    10G CWDM SFP+ transceiver 100km is CE/RoHS certified and meets product safety standards. SFP+ Multi Source Agreement SFF-8431 and IEEE 802.3ae 10GBASE-ZR are fully supported by the 100km CWDM SFP+ 10G Transceiver. As a result, the module is compatible with 80% of networking equipment where no special algorithm for protection against third-party modules is implemented. However, we can provide an SFP+ transceiver with custom-encoded firmware that will work in almost any equipment. Because we are committed to providing high-quality service, we conduct rigorous quality checks before delivering our products. As a result, we perform optical parameter measurements, connector cleanness tests, and EEPROM memory data validation tests on SFP+ transceivers. Please contact us if you require any additional information.